Hits
Automatic Remote Controlled Antenna Tuner
This tuner is designed to match remotely, both balanced and unbalanced HF antennas
post 04 Oct 2024
Antenna Transmatch tuner Links →
A Balanced Balanced Antenna Tuner
As a rule of thumb, a balun should have about 4 times as many reactive ohms as the resistive ohms of the load. This means that for use with a 600ohm balanced load, the balun should have a secondary winding reactance of about 2400ohm
Automatic Tuner Project
I have been accumulating parts from ham swap meets for several years for a medium power antenna tuner. The tuner is a high pass T-network tuner
A Homebrew Z-Match Transmatch
The coil was wound using some #22 solid hookup wire (from Radio Shack) which I had lying around. The secondary winding is wound between the turns of the primary to ensure tight coupling
Accordatore HF d'antenna
piccolo transmatch Hf che permette di utilizzare lo yaesu FT-757 GX
193
As a rule of thumb, a balun should have about 4 times as many reactive ohms as the resistive ohms of the load. This means that for use with a 600ohm balanced load, the balun should have a secondary winding reactance of about 2400ohm
I have been accumulating parts from ham swap meets for several years for a medium power antenna tuner. The tuner is a high pass T-network tuner
The coil was wound using some #22 solid hookup wire (from Radio Shack) which I had lying around. The secondary winding is wound between the turns of the primary to ensure tight coupling
piccolo transmatch Hf che permette di utilizzare lo yaesu FT-757 GX
23cm Yagi Antenna building Finished antenna at 1275 MHz SWR under 1:1.5 at resonant frequency
50 MHz preamp Gain 26dB with the BFG135 Preamps for 144 and 430 MHz, for 50 MHz, the BFG135a is a cheap transistor and in my view rather strong. It is not easily damaged by static discharge or RF power. FG connection
Interface-for-digital-broadcasts-with-integrated-audio 4-port HUB, with a TUSB2046. With port 1 of the HUB we drive the FT232RL; with port 2 the PCM2904, furthermore, we decided to leave ports 3 and 4 free