Hits 

160 Meter Antenna for limited space


160 Meter Antenna for limited space. The height and width can be adjusted to fit the available area. Total length of the wire is approx. 125 feet. The single wire passes through the insulators. The weight must be secured to the wire so that it will not slide
post 28 Jan 2024
160 Meter Antenna for limited space

Antenna 160 meter Links

90



160m inverted L antenna
Inverter L base at ground level with a significantly lower noise level compared to the 80/40 double, especially when the ground is damp. I will use it promptly as it is now, and will add radials within the next 160 season

Reduced-Size Half Sloper For 160 Meters
Yes, most 160-meter antennas are big. A full sized half wavelength dipole is about 260 feet long! But with a little creative design work, it's possible to build limited space antennas that will get you on the band without sacrificing too much real estate

160 Meter sloper
This antenna ships 70' in length and will be trimmed back to 68' or less on installation. It works best when attached to your tower/pole at about the 45 50' level. This allows the radiator wire to be angled down toward the ground at a comfortable angle somewhere near 45 degrees

Working 160M From a Small Lot
A straight quarter-wave Best 1/4 - 125 ft at 1830 kHz with THHN Inverted L Good Go straight up as high as you can with a wire, then bend the remaining wire to run horizontal to resonate it Tee vertical A bit better than L - Like an inverted L, but the top is extended in opposite directions

Shunt Fed Tower for 160 Meters
60 Meters 130 foot free standing towershunt fed with omega match 160m Shunt Fed Tower50 Ohm Coax toShackC ShuntC Series8 Wire Cage82 ft tall, 12,1/2


23cm Yagi Antenna building

23cm Yagi Antenna building Finished antenna at 1275 MHz SWR under 1:1.5 at resonant frequency

50 MHz preamp Gain 26dB with the BFG135

50 MHz preamp Gain 26dB with the BFG135 Preamps for 144 and 430 MHz, for 50 MHz, the BFG135a is a cheap transistor and in my view rather strong. It is not easily damaged by static discharge or RF power. FG connection

interface-for-digital-broadcasts-with-integrated-audio

Interface-for-digital-broadcasts-with-integrated-audio 4-port HUB, with a TUSB2046. With port 1 of the HUB we drive the FT232RL; with port 2 the PCM2904, furthermore, we decided to leave ports 3 and 4 free