Hits
Antenna multibanda windom
Questa semplice antenna multibanda lavora su tutte le gamme HF, dai 3.5 ai 30 MHz, incluso le bande WARC
post 20 May 2024
Antenna Multibands Links →
My homebrew vertical multiband hf antenna
I have 5 band vertical HF antenna without lossy traps, stubs, loading coils, a 1/4 wave on each band that already survived two small storms
Off Center Feed Dipole all ham-bands 160M-10M
This Off Center Feed Dipole antenna OCDF is used on all ham-bands 160M-10M. I'm using it with my PALSTAR AT1KP
QRO No Tuner Multiband Dipole
One of the last upgrades to the dipole before experimenting with high-power tuning was to change the 300 ohm window line to 600 ohm ladder line. The higher-Z open-wire lines experience less loss overall, which means that they can operate at higher SWR than the lower-Z lines for a given loss value
Rhombic-Math Antenna
Termination resistor needs to be near 800Ω Resistors must be carbon resistance not inductive
156
I have 5 band vertical HF antenna without lossy traps, stubs, loading coils, a 1/4 wave on each band that already survived two small storms
This Off Center Feed Dipole antenna OCDF is used on all ham-bands 160M-10M. I'm using it with my PALSTAR AT1KP
One of the last upgrades to the dipole before experimenting with high-power tuning was to change the 300 ohm window line to 600 ohm ladder line. The higher-Z open-wire lines experience less loss overall, which means that they can operate at higher SWR than the lower-Z lines for a given loss value
Termination resistor needs to be near 800Ω Resistors must be carbon resistance not inductive
23cm Yagi Antenna building Finished antenna at 1275 MHz SWR under 1:1.5 at resonant frequency
50 MHz preamp Gain 26dB with the BFG135 Preamps for 144 and 430 MHz, for 50 MHz, the BFG135a is a cheap transistor and in my view rather strong. It is not easily damaged by static discharge or RF power. FG connection
Interface-for-digital-broadcasts-with-integrated-audio 4-port HUB, with a TUSB2046. With port 1 of the HUB we drive the FT232RL; with port 2 the PCM2904, furthermore, we decided to leave ports 3 and 4 free