Hits
A Co-ax Trap Dipole For 40, 30 and 20 Meters
Another way to minimise the loss of an antenna using coax traps is to use the minimum length of coax needed to achieve resonance
post 04 Dec 2024
Antenna Multibands Links →
My homebrew vertical multiband hf antenna
I have 5 band vertical HF antenna without lossy traps, stubs, loading coils, a 1/4 wave on each band that already survived two small storms
Off Center Feed Dipole all ham-bands 160M-10M
This Off Center Feed Dipole antenna OCDF is used on all ham-bands 160M-10M. I'm using it with my PALSTAR AT1KP
QRO No Tuner Multiband Dipole
One of the last upgrades to the dipole before experimenting with high-power tuning was to change the 300 ohm window line to 600 ohm ladder line. The higher-Z open-wire lines experience less loss overall, which means that they can operate at higher SWR than the lower-Z lines for a given loss value
Rhombic-Math Antenna
Termination resistor needs to be near 800Ω Resistors must be carbon resistance not inductive
156
I have 5 band vertical HF antenna without lossy traps, stubs, loading coils, a 1/4 wave on each band that already survived two small storms
This Off Center Feed Dipole antenna OCDF is used on all ham-bands 160M-10M. I'm using it with my PALSTAR AT1KP
One of the last upgrades to the dipole before experimenting with high-power tuning was to change the 300 ohm window line to 600 ohm ladder line. The higher-Z open-wire lines experience less loss overall, which means that they can operate at higher SWR than the lower-Z lines for a given loss value
Termination resistor needs to be near 800Ω Resistors must be carbon resistance not inductive
PIC-Keyer This project describes the construction of a real "QRP" keyer with a small microcontroller PIC 16F84, with slightly modified hardware also PIC16F62
Radioassistance Radioassistance E Kenwood Dealer, vendita ricetrasmittenti, antenne, parti di ricambio, elettronica
Conrad Electronic Electronic components online shop in German and Italian