Hits
2 meter VHF Antennas 7 elements and 10
2 meter VHF Antennas 7 elements and 10
post 29 Jan 2024
Antenna for UHF VHF Links →
Antenna double bands 144/432 mhz
Questa antenna e' lunga circa 1,5 metri solo circa 30 centimetri in piu' di una quattro elementi a spaziatura costante classica
Antenna YAGI a 6 elementi per i 2 metri
Il boom e' lungo 1,75 m sezione 1,8 x 1,8 cm, il riflettore 50,3 cm, il radiatore 48,9 cm, d1 44,9cm, d2 44,3 cm, d3 40,8 cm, d4 39,5cm
Antenna Yagi 4 elementi UHF
Adaptation with hairpin on uhf is very functional and stable, and above all it is preferable to the match range
Antenna Double loop rx satellite 137.5mhz
operating frequency = 130 to 170 MHz ,center frequency = 137.5 MHz, perimeter of loops = 227 cm, material used = copper or aluminum = 227x3x0.2 cm, horizontal polarization gain 3 dbd
Antenna for 6 meter band Halo
A square folded dipole radiates in all directions, with -4dB gain on the sides compared to the front and back side
154
Questa antenna e' lunga circa 1,5 metri solo circa 30 centimetri in piu' di una quattro elementi a spaziatura costante classica
Il boom e' lungo 1,75 m sezione 1,8 x 1,8 cm, il riflettore 50,3 cm, il radiatore 48,9 cm, d1 44,9cm, d2 44,3 cm, d3 40,8 cm, d4 39,5cm
Adaptation with hairpin on uhf is very functional and stable, and above all it is preferable to the match range
operating frequency = 130 to 170 MHz ,center frequency = 137.5 MHz, perimeter of loops = 227 cm, material used = copper or aluminum = 227x3x0.2 cm, horizontal polarization gain 3 dbd
A square folded dipole radiates in all directions, with -4dB gain on the sides compared to the front and back side
23cm Yagi Antenna building Finished antenna at 1275 MHz SWR under 1:1.5 at resonant frequency
50 MHz preamp Gain 26dB with the BFG135 Preamps for 144 and 430 MHz, for 50 MHz, the BFG135a is a cheap transistor and in my view rather strong. It is not easily damaged by static discharge or RF power. FG connection
30 Volt Computer Power Supply Stack A bonus was that i discovered that these did not need a standby load connected to the supply to keep them running just apply mains power and close the Start lead to ground