Hits
A single coil z-match
This ATU being balanced can accomodate balanced line, open wire feeder or 300 ohm slotted
post 20 Jun 2024
Antenna Transmatch tuner Links →
Build hf antenna tuner
This page details several T-match tuners. By comparing them, you should be able to construct a tuner to your own particular requirements
Realization of a coupling box by Patrice
The torus has 6 wires: 2 side CV, 2 side self and 2 to the outputs of the box, for the RX - TX.- For the six outputs of the torus, put "souplisso" recovered on the transformer of a micro insulation 2000 volts
Box agreement antenna with coil with caster and 4 CV isolated
From the left to the right we see the balun on the ferrite bar, the 4-cage CV and the roller coaster.
Box Antenna tuner monobande 28/30 MHz
Like the 10 MHz mono-band box, this box operates in autotransfo. The permissible power is greater than 200 watts
197
This page details several T-match tuners. By comparing them, you should be able to construct a tuner to your own particular requirements
The torus has 6 wires: 2 side CV, 2 side self and 2 to the outputs of the box, for the RX - TX.- For the six outputs of the torus, put "souplisso" recovered on the transformer of a micro insulation 2000 volts
From the left to the right we see the balun on the ferrite bar, the 4-cage CV and the roller coaster.
Like the 10 MHz mono-band box, this box operates in autotransfo. The permissible power is greater than 200 watts
23cm Yagi Antenna building Finished antenna at 1275 MHz SWR under 1:1.5 at resonant frequency
50 MHz preamp Gain 26dB with the BFG135 Preamps for 144 and 430 MHz, for 50 MHz, the BFG135a is a cheap transistor and in my view rather strong. It is not easily damaged by static discharge or RF power. FG connection
30 Volt Computer Power Supply Stack A bonus was that i discovered that these did not need a standby load connected to the supply to keep them running just apply mains power and close the Start lead to ground