Coax cables specifications

Hits

Coax cables specifications

Coax cables specifications

RG213 attenuation: 1.2 dB per 100 ft at 30 MHz and less

post 21 Dec 2024

System Grounding Links →

33

In-shack Ground System
The grounding project is coming along

Introduction to coaxial cables
A coaxial cable is one that consists of two conductors

Lightning Protection forthe Amateur Radio Station
good external ground system to complete your station’s protection

Amateur Radio Station Grounding Common Practic
I’ve installed a ground bus, a piece of 22mm copper pipe, the equipment is all grounded radially

Psion ham software

PSION Greyline Clock PSION Greyline Clock v. 1.0 is a UTC/Local clock showing sunlight/darkness area on the world map

Radioassistance

Radioassistance Radioassistance E Kenwood Dealer, vendita ricetrasmittenti, antenne, parti di ricambio, elettronica

SunCalc

SunCalc SunCalc - sunrise, sunset, shadow length, solar eclipse, sun position, sun phase, sun height, sun calculator, sun movement, map, sunlight phases, elevation, Photovoltaic

Simple Rtty codec system based on arduino e android A unit for receiving Rtty transmissions was created, the differences are essentially limited to the Arduino software used

All band dipole Mk2 The All Band HF Doublet is often referred to as a random length dipole as it is generally as long as the available space within reason, but here are a couple of limitations to the ultimate dipole length

160M 1/4 Wave Vertical 160m vertical antenna project. It is 100' of Rohn 25G and a 20' aluminum stinger. The base is made out of four 6' power line insulators sandwiched between two Rohn base plates. 7/8' stainless bolts hold the assembly together. 32 radials 50' long and 30 radials 100'

DHD Double Half Delta

DHD Double Half Delta This is a dhd double half delta in theory it should return a low signal but with a good s - n ratio roughly like a beverage

Visual CW Tuning Indicator

Visual CW Tuning Indicator Many transceivers set the CW transmit off-set equal to the set's sidetone frequency. But it was left to the operator how to match incoming signals to the sidetone for one-frequency QSOs an awkward and time-consuming procedure

Convert ADIF to Cabrillo Format

Convert ADIF to Cabrillo Format Have an ADIF file from amateur radio contesting, but the contest you want to enter wants a Cabrillo-formatted file? This is the tool that you need

trap-dipole-7-10-14-18-50-mhz

Trap Dipole 7, 10, 14, 18, 50 MHz Trap dipole 7-10-14-18-50mhz with balun coax cable

Diy Arduino CW keyer

Diy Arduino CW keyer I added code to read push-buttons on digital pins to trigger hard-coded messages like CQ and CQ SOTA