Hits 

Multi-band antenna for the 80, 40, 20, 17, 12, 10 and 6 meter


Project for a multi-band antenna for the 80, 40, 20, 17, 12, 10 and 6 meter bands, including a 1:4 impedance transformer and a current balun handling 800 Watt
post 04 Jun 2024
Multi-band antenna for the 80, 40, 20, 17, 12, 10 and 6 meter

Antenna Multibands Links

156



Antenna multigamma a L rovesciata
L rovesciata, forse la cenerentola fra le antenne, che pero' ha il pregio di essere di una semplicita estrema meno di cosi'si rinuncia all'antenna

Antenna filare doublet
La Doublet antenna altro non e' che un dipolo multibanda tagliato per la piu' bassa frequenza di lavoro e alimentato al centro da una linea bifilare da 300 Ohm

Antenna on the 1.8 - 10.1 MHz bands
It is known that the best from non-directional DX antennas for communications on the low bands are vertical, having a low zenith angle of radiation. But quarter wave height at 1.8 MHz 39 m

Antenna W3DZZ
The standard version of the Antenna, L - 8.3 uH wound on a frame d - 50 mm. length 8 windings 80 mm. number of turns 19 C = 60 PF. The contour is tuned to the GIR frequency?, 05 MHz

Antenna Windom la multigamma
L'antenna Windom, la quale non e' altro che un dipolo avente una certa lunghezza ed alimentato ad un terzo anziche' a meta. Mi spiego meglio: se noi prendiamo un dipolo lungo meta' lunghezza d'onda che risuona sugli 80 metri e lo alimentiamo al centro con un balun 1:1, avremo come detto la risonanza su tale banda


23cm Yagi Antenna building

23cm Yagi Antenna building Finished antenna at 1275 MHz SWR under 1:1.5 at resonant frequency

50 MHz preamp Gain 26dB with the BFG135

50 MHz preamp Gain 26dB with the BFG135 Preamps for 144 and 430 MHz, for 50 MHz, the BFG135a is a cheap transistor and in my view rather strong. It is not easily damaged by static discharge or RF power. FG connection

30 Volt Computer Power Supply Stack

30 Volt Computer Power Supply Stack A bonus was that i discovered that these did not need a standby load connected to the supply to keep them running just apply mains power and close the Start lead to ground