Hits 

Vertical antenna balloon for the 80m band


The antenna could not be simpler - 1/4 or 1/2 wavelength of thin copper wire, used 35 SWG enamalled copper wire. This amounts to 20 or 40m of wire. It is carefully coiled up on the wire spool with one end soldered to a tag. When the balloon is let free it pulls the wire from the spool and it goes up at a nice slow pace. Once up, a croc-clip goes from the ATU coil to the solder tag - the antenna is connected
post 13 May 2024
Vertical antenna balloon for the 80m band

Antenna 80 meter Links

76



80 Meter Tower Vertical with Short Radials

The modelled resistance component of the feed point impedance at 3.65 MHz is 80 ohm. It is high due to ground loss and being well off resonance. I chose to simply place a capacitor load in series with tower monopole, chosen to have a reactance of equal magnitude to the inductive reactance of 44 ohm at 3.65 MHz. This requires a capacitor of 1000 pf

Single Support Gain Antennasfor 80 and 160 Meters
Examples of antenna ,Sloper Arrays, having a tower

Dual Band Antenna 40-80m
PVC Diameter 50mm, total coil turns 78, wire 1.25 mm, for PVC size Diameter 42mm (1 1/4′) the number of turns 89 turns around 100uh

Dipolo rigido nvis 40-80m
Dipolo caricato sulle bande dei 40m-80m

Skyloop Antenna 3.5 to 50 MHz
I decided to try a new type of hf antenna skyloop or deltaloop


Antenna splitter per VHF-UHF per quattro ricevitori

Antenna splitter per VHF-UHF per quattro ricevitori Chi dispone di una sola antenna e vuole collegarvi più di un ricevitore necessità di uno splitter

Kits and Components

Amateur radio kits by Kanga US

50MHz to 28MHz RX Converter

50MHz to 28MHz RX Converter The concept of the rx converter is quite simple and nothing really new. the local oscillator is a standard colpitts crystal oscillator producing the 22mhz lo signal