5 Element-Yagi fur 145 MHz

Hits

5 Element-Yagi fur 145 MHz

This site is intended to allow all DIY enthusiasts and newcomers a little insight into the antenna self-construction

post 06 May 2024

5 Element-Yagi fur 145 MHz

Antenna for UHF VHF Links →

155

Building UHF Antennas
His method of construction can be used on most UHF through "low" microwave Yagis, and is especially useful for the 33, 23 and 13 cm bands

Build a 2m 8db collinear for £20
I started to build the antenna by cutting four lengths of wire, the measurement is 38.75ins for a half wave 145mhz but I cut them at 39.75ins

HB9CV 144mhz
Symmetrical model, 75 ohm asymmetrical model

PIC-Keyer

PIC-Keyer This project describes the construction of a real "QRP" keyer with a small microcontroller PIC 16F84, with slightly modified hardware also PIC16F62

Radioassistance

Radioassistance Radioassistance E Kenwood Dealer, vendita ricetrasmittenti, antenne, parti di ricambio, elettronica

Conrad Electronic

Conrad Electronic Electronic components online shop in German and Italian

Antenna Morgain for 40-80m This antenna has in its main characteristic, the fact that with only 20 mt. the 80 meters of space occupied it

All band dipole Mk2 The All Band HF Doublet is often referred to as a random length dipole as it is generally as long as the available space within reason, but here are a couple of limitations to the ultimate dipole length

160M 1/4 Wave Vertical 160m vertical antenna project. It is 100' of Rohn 25G and a 20' aluminum stinger. The base is made out of four 6' power line insulators sandwiched between two Rohn base plates. 7/8' stainless bolts hold the assembly together. 32 radials 50' long and 30 radials 100'

DHD Double Half Delta This is a dhd double half delta in theory it should return a low signal but with a good s - n ratio roughly like a beverage

Visual CW Tuning Indicator Many transceivers set the CW transmit off-set equal to the set's sidetone frequency. But it was left to the operator how to match incoming signals to the sidetone for one-frequency QSOs an awkward and time-consuming procedure

Convert ADIF to Cabrillo Format

Convert ADIF to Cabrillo Format Have an ADIF file from amateur radio contesting, but the contest you want to enter wants a Cabrillo-formatted file? This is the tool that you need

trap-dipole-7-10-14-18-50-mhz

Trap Dipole 7, 10, 14, 18, 50 MHz Trap dipole 7-10-14-18-50mhz with balun coax cable

Diy Arduino CW keyer

Diy Arduino CW keyer I added code to read push-buttons on digital pins to trigger hard-coded messages like CQ and CQ SOTA