Hits
Balun coaxial 20. At 27 MHz
The length of the balun in Figure C must be Length = Wavelength / 20. At 27 MHz, the capacitor will be approximately 120 pF. It may be expedient here to use a trim capacitor, in order to obtain an optimum fit in this way
post 19 Apr 2024
Toroid & balun Links →
1:4 Balun, ON6MU
Balun for folded dipoles
4:1 balun for 160 to 10 meters
Here we calculate the half wave length of the matching section of the 4:1 coax balun
4:1 coax balun design CALCULATOR
Here we calculate the half wave length of the matching section of the 4:1 coax balun
50 ohm single-band baluns
The balun herein described is suitable for 50-ohm monoband antennas which can often represent a valid choice
JI -Test, measure balun, and compare antenna baluns or balums
Many articles and technical sources on baluns or balun design ignore voltage, focusing only on current. Focusing only on current is a serious oversight that can result in defective system design
202
Balun for folded dipoles
Here we calculate the half wave length of the matching section of the 4:1 coax balun
Here we calculate the half wave length of the matching section of the 4:1 coax balun
The balun herein described is suitable for 50-ohm monoband antennas which can often represent a valid choice
Many articles and technical sources on baluns or balun design ignore voltage, focusing only on current. Focusing only on current is a serious oversight that can result in defective system design
23cm Yagi Antenna building Finished antenna at 1275 MHz SWR under 1:1.5 at resonant frequency
50 MHz preamp Gain 26dB with the BFG135 Preamps for 144 and 430 MHz, for 50 MHz, the BFG135a is a cheap transistor and in my view rather strong. It is not easily damaged by static discharge or RF power. FG connection
Interface-for-digital-broadcasts-with-integrated-audio 4-port HUB, with a TUSB2046. With port 1 of the HUB we drive the FT232RL; with port 2 the PCM2904, furthermore, we decided to leave ports 3 and 4 free