Hits
Balun Test
Many articles and technical sources on baluns or balun design ignore voltage, focusing only on current. Focusing only on current is a serious oversight that can result in defective system design
post 20 Oct 2024
Toroid & balun Links →
1:1 Balun for HF wire
1:1 50 ohm balun for use on HF horizontal wire dipoles. It uses an AM radio ferrite rod, with 3x14 turns of wire. 10-14 turns should be good for 2-30MHz. 18SWG enammeled copper wire
Binocular ferrite 9:1 balun RX Transformer
There are lots of good designs for matching transformers for receiving antennas. it's cheap and easy, and very high performance
1:9 Antenna balun
I had this feeling the 1:4 balun was not presenting the greatest match to the open feed line. After I built and tried this 1:9 balun the autotune antenna tuner was able to
1:9 Antenna Long Wire con Balun 9:1
Vi occorre un antenna semplice e di sicuro funzionamento, in pochi minuti potrete costruirvi una Long Wire (filo lungo) o corto, fate voi
202
1:1 50 ohm balun for use on HF horizontal wire dipoles. It uses an AM radio ferrite rod, with 3x14 turns of wire. 10-14 turns should be good for 2-30MHz. 18SWG enammeled copper wire
There are lots of good designs for matching transformers for receiving antennas. it's cheap and easy, and very high performance
I had this feeling the 1:4 balun was not presenting the greatest match to the open feed line. After I built and tried this 1:9 balun the autotune antenna tuner was able to
Vi occorre un antenna semplice e di sicuro funzionamento, in pochi minuti potrete costruirvi una Long Wire (filo lungo) o corto, fate voi
23cm Yagi Antenna building Finished antenna at 1275 MHz SWR under 1:1.5 at resonant frequency
50 MHz preamp Gain 26dB with the BFG135 Preamps for 144 and 430 MHz, for 50 MHz, the BFG135a is a cheap transistor and in my view rather strong. It is not easily damaged by static discharge or RF power. FG connection
Interface-for-digital-broadcasts-with-integrated-audio 4-port HUB, with a TUSB2046. With port 1 of the HUB we drive the FT232RL; with port 2 the PCM2904, furthermore, we decided to leave ports 3 and 4 free