Hits 

The W3EDP end fed wire antenna


A simple matching unit is needed to couple the wire to the rig and a counterpoise is required for some bands
post 12 Apr 2026
The W3EDP end fed wire antenna

Antenna End Fed Links →

78



End fed-Halfe-wave antenna
This type of antenna has same performance as a dipole, but requires only one single mounting point, which makes this concept ideal for portabel stations. Actual bandwith is more than 2 Mhz with VSWR better than 1:1,7

End fed half wave antenna EFHWA
Un solo filo,tagliato alla 1\2 onda della frequenza desiderata,alimentato ad un'estremita'

End-Fed Monobanda
E' consigliato l'uso dei toroidi in polvere di ferro anziche' in ferrite, almeno fino a circa 200-300 watts

End Fed Half Wave Antenna Coupler
A dipole can be fed anywhere along its length. A centre feed gives around 70 ohm. A Windom type off centre fed dipole fed 38% along its length provides around a 200 ohm feed. The feed impedance at the very end of a half wave is thousands of ohms, usually somewhere between 2000 ohm to 5000 ohm

End-Fed Wire Antenna
Ho costruito questa simpatica antenna dopo aver trovato un piccolo toroide cheassomiglia parecchio al T80


Microsat

Microsat Ham radio shop for ulari project, aprs, aprs with radio, bluetooth, gps, gsm, ham radio interfaces, weather,accessories, cables to radio

Kits and Components

Amateur radio kits by Kanga US

Enigma Component Shop

Enigma Component Shop Cable & wire,capacitors, connectors, crystals/oscillators, filters, hardware,kits/modules,test & measurement