Hits
QRPGuys Portable No Tune End Fed Half Wave Antenna
Single band, 80m-10m end fed half wave wire antenna. It is designed as a highly portable wire antenna, easily set up as an inverted V, horizontal, sloper, or in the case of higher frequencies, a vertical radiator. Your feed line is essentially the counterpoise, so a separate one is not needed. The high impedance, half wave wire is matched to your 50 ohm feed point by an integral impedance matching toroid transformer, and rated is at 10 watts
post 17 Jun 2024
Antenna End Fed Links →
160 meter end fed
With this length of wire a coil of 11 turns is required, resonating the antenna on 1.950MHz with an SWR of 1.5:1
10 20 40m Endfed antenna
It's has a large bandwidth with a low SWR and has no radials
40m End Fed Half Wave EFHW Antenna
The feed point of the EFHW is in the order of 3000 to 5000 ohms while the 1/2 wave dipole will be closer to 50 ohms in the inverted V configuration
60 Meter End Fed Half Wave Antenna Tuner
63
With this length of wire a coil of 11 turns is required, resonating the antenna on 1.950MHz with an SWR of 1.5:1
It's has a large bandwidth with a low SWR and has no radials
The feed point of the EFHW is in the order of 3000 to 5000 ohms while the 1/2 wave dipole will be closer to 50 ohms in the inverted V configuration
PIC-Keyer This project describes the construction of a real "QRP" keyer with a small microcontroller PIC 16F84, with slightly modified hardware also PIC16F62
RF Inductance Calculator Mean diameter of the air core coil, measured from conductor centre to conductor centre include the wire insulation thickness, if any
Voice Recorder Gestito dall'integrato in questione ed offre la possibilità di registrare più messaggi per una durata massima di un minuto con buona fedeltà di riproduzione