Hits
Configurazioni antenna end-fed
End Fed Hertz trasformazione d'impedenza e contrappeso
post 31 May 2024
Antenna End Fed Links →
End fed antenna lambda/2
drastically lower the impedance with a toroid FT240-43 on which we are going to wrap 14 + 2 coils of copper from 1mm
End fed 1/2 wave matching system end feed
Actual bandwith is more than 2 Mhz with VSWR better than 1:1,7 For 14 Mhz you need approx. 10 meters of wire, abt. 4,7m coax-cable 50Ohm or 300Ohm with a connector about 30cm from the shortend end
End-Fed Half-Wave Antenna & Tuner
The final device tunes a resistive load of 3-7 kilo-Ohms from 3.2 MHz to 12.6 MHz. 40 metres is covered and 30 metres too, but I lack a transceiver for it currently
HF End Fed Half Wave
The SWR is likely to be below 1:1.5 and when used as an omnidirectional vertical the low angle of radiation typically with a maximum at about 20 degrees will give good results on DX
63
drastically lower the impedance with a toroid FT240-43 on which we are going to wrap 14 + 2 coils of copper from 1mm
Actual bandwith is more than 2 Mhz with VSWR better than 1:1,7 For 14 Mhz you need approx. 10 meters of wire, abt. 4,7m coax-cable 50Ohm or 300Ohm with a connector about 30cm from the shortend end
The final device tunes a resistive load of 3-7 kilo-Ohms from 3.2 MHz to 12.6 MHz. 40 metres is covered and 30 metres too, but I lack a transceiver for it currently
The SWR is likely to be below 1:1.5 and when used as an omnidirectional vertical the low angle of radiation typically with a maximum at about 20 degrees will give good results on DX
Ferrite Shop Ferrite-shop on-line shop, cable clamps,toroids, cable cores, technic,ferrite material choice
Amateur radio kits by Kanga US
Pcs Electronics RF power amplifiers-pallets archives-ABC of FM AM DAB+ DRM radio transmitters