Hits
DB37-FT-2000 Cable
can be used with the following microHAM interfaces
post 22 Jun 2024
Microphone Setting Links →
Kenwood MC-50 modification
There have been a few instances of improper VOX operation when the MC-50 microphone is used
Kenwood Mc-60 to Icom IC746
MC‐60APinConnections,BeforeandAfterModifications,forUsewithICOMRadios
Kenwood Pin Connectors
During the past eleven years many hours have been spent drawing diagrams producing photographs, compiling these lists and cross
Kenwood TR-7950 Microphone Pinout
I looked through the internet for a microphone pinout for this Kenwood I was given. The wires had been yanked from the mic connect
Low Noise Microphone Preamplifier
This is a design for a low noise microphone preamplifier, which is ideally suited to low impedance 600 Ohm nominal microphones
44
There have been a few instances of improper VOX operation when the MC-50 microphone is used
MC‐60APinConnections,BeforeandAfterModifications,forUsewithICOMRadios
During the past eleven years many hours have been spent drawing diagrams producing photographs, compiling these lists and cross
I looked through the internet for a microphone pinout for this Kenwood I was given. The wires had been yanked from the mic connect
This is a design for a low noise microphone preamplifier, which is ideally suited to low impedance 600 Ohm nominal microphones
23cm Yagi Antenna building Finished antenna at 1275 MHz SWR under 1:1.5 at resonant frequency
50 MHz preamp Gain 26dB with the BFG135 Preamps for 144 and 430 MHz, for 50 MHz, the BFG135a is a cheap transistor and in my view rather strong. It is not easily damaged by static discharge or RF power. FG connection
Interface-for-digital-broadcasts-with-integrated-audio 4-port HUB, with a TUSB2046. With port 1 of the HUB we drive the FT232RL; with port 2 the PCM2904, furthermore, we decided to leave ports 3 and 4 free