Hits
Base Loaded 160M Half-Sloper Antenna
Construction is pretty straight forward, drill end caps for 3/8-24 hardware ring connector on end of wire that was fed through PVC tube for cap.wrap wire around coil form
post 26 Mar 2024
Antenna 160 meter Links →
160 meter vertical antenna's base loading
The following pictures show what my 160M vertical antenna base loading and matching coil assembly looks like. Yes, I managed to shoot a line up over one of my HUGE about 135 feet tall
160m antenna
This picture shows the first 70 feet 21.3 metre of pvc insulated wire wound over a 2 inch 50mm pvc conduit. The length approaches 5 foot six inches
160 Meter Antenna for limited space
The height and width can be adjusted to fit the available area. Total length of the wire is approx. 125 feet. The single wire passes through the insulators.The weight must be secured to the wire so that it will not slide
Antenne Verticale 18m pourle 30/80/160m
10m Vertical and 30m Horizontal 12 radians of 8m, 2 of 16m, 2 of 10m, 2 of 40m
160m and 60m Inverted L project
In total 1600 ft of 14 gauge solid was used in the radial system, resulting in 16 radials each 100ft in length. Of the bunch 7 are buried in areas where vehicles and horses roam
96
The following pictures show what my 160M vertical antenna base loading and matching coil assembly looks like. Yes, I managed to shoot a line up over one of my HUGE about 135 feet tall
This picture shows the first 70 feet 21.3 metre of pvc insulated wire wound over a 2 inch 50mm pvc conduit. The length approaches 5 foot six inches
The height and width can be adjusted to fit the available area. Total length of the wire is approx. 125 feet. The single wire passes through the insulators.The weight must be secured to the wire so that it will not slide
10m Vertical and 30m Horizontal 12 radians of 8m, 2 of 16m, 2 of 10m, 2 of 40m
In total 1600 ft of 14 gauge solid was used in the radial system, resulting in 16 radials each 100ft in length. Of the bunch 7 are buried in areas where vehicles and horses roam
Linear loaded short dipole 21Mhz For my amateur radio activities on the HF bands I only have a 3.6 m wide balcony available for antennas. After some study I decided to experiment with a shortened dipole for the 15 m band
Rx antennas 4Square Rx Vertical Array My frequency design of 1.825 MHz a 90 degrees line would be 33,70 metersinstead of the previously calculated 33,27 m
Atu balanced feeder antenna system An ATU has the advantage of bringing the feeder-antenna system to resonance, act as a band pass filter both on receive and transmit and a low SWR